Lectrosonics R33 Manual de usuario

Performer CUT OFF THIS 2’ SECTION BASE SPRING AMPHENOL 83-1SP PLUG (or equivalent) TO REMOTE ANTENNA CONNECTOR ON R33 SERIES RECEIVER FIG. 6 CB ANTE

Professional Wireless System 7. SYSTEM SETUP AND OPERATION The following steps should be done in order. If you have any problems with

Performer 8. MULTIPLE M33 / R33 SYSTEMS In multiple wireless system setups there must be an R33 receiver for each M33 transmitter used. Each M

Professional Wireless System 9. TROUBLE SHOOTING wireless system malfunctions, you should attempt to correct or isolate the trouble before c

TABLE B REPLACEMENT PARTS AND ACCESSORIES CAT. NO. ITEM DESCRIPTION USE A-54 Antenna, telescoping, 54” Replacement antenna for R33 series r

Performer LECTROSONICS, INC. 2

LECTROSONICS, INC. 581 LASER ROAD RIO RANCHO, NM 87124 USA www.lectrosonics.com January 12, 2005 (Created from old paper copy.)

Professional Wireless System TABLE OF CONTENTS GENERAL ...

Performer 1. GENERAL READ THE MANUAL This manual contains the functional description, operating instructions and troubleshooting procedures f

Professional Wireless System 3. M33 SERIES TRANSMITTER (see figure 1) The GAIN ADJUSTMENT sets the audio gain of the M33 to match differen

Performer Some of the most popular microphones come with a set screw that locks the mic cable connector to the bottom of the microphone. This set

Professional Wireless System 4. R33 RECEIVER FRONT PANEL (see figure 3) The green LED RF indicator light lights when there is sufficien

Performer 5. R33 RECEIVER REAR PANEL (see figure 4) The BAL MIC (balanced microphone) output, a switchcraft D3M connector, is the most commo

Professional Wireless System 6. REMOTE ANTENNAS If the screw in whip antenna provided with the R33 cannot be used due to receiver location,