Lectrosonics SMDa Manual de usuario descargar pdf (Pagina 17)

     

         

        

          

       

Super-Minature Belt Pack Transmitters

Operating Notes

• The sensitivity to the remote

control varies with the trans-

mitter’s audio level setting

and the microphone used, but

it is always possible to make

it work with a sufﬁciently loud

remote signal at close range.

• If the SMa is congured to

respond to the remote con-

trol, it will do so even if the

buttons are locked.

• When the SMa is asleep, it

can only be awakened by the

remote control, or by remov-

ing and reinserting the bat-

tery.

• When the SM is asleep, the

PWR led blinks green every

few seconds.

• If a remote command is sent that would result in

the same display being shown again on the SM (for

example tuning to the channel already displayed),

a row of dashes is displayed brieﬂy, as a signal that

the command was received, but it didn’t change

anything.

• If you are having trouble getting the SMa to re-

spond, make sure you aren’t covering the RM’s

speaker with your thumb, and/or turn up the RM’s

speaker volume on the “Loud” page.

• If the RM is set to a different block number than

the transmitter and an attempt is made to set the

transmitter’s frequency in MHz, the command

will still work. The transmitter is simply set to the

corresponding channel in the correct block, with a

matching hex code.

• Since all SM transmitters respond to the same sig-

nals, take care that the remote control is presented

only to the desired transmitter, with the minimum

speaker volume necessary to do the job reliably.

Note: The audio signal from the RM will change

the settings of all transmitters within range.

Experiment with this to prevent accidental changes

to another transmitter during a production.

The RM should be held close enough to the microphone to

change the settings on the intended transmitter, but not be so

loud as to affect other transmitters nearby.

RM Quick Reference

Power On/Off AUDIO+FREQ

Set SM audio level Aud page (via AUDIO)

Sleep or Wake SM SLEEP/unSLP page (via AUDIO)

Lock or Unlock SM Loc/unLoc page (via AUDIO)

Adjust RM volume Loud page (via AUDIO)

Set SM channel (hex) CH page (via FREQ)

Enable MHz display b (block) page (via FREQ)

Set SM channel (MHz) 000.000 page (via FREQ)

Rio Rancho, NM

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Comentarios a estos manuales

Sin comentarios

Lectrosonics SMDa Manual de usuario Pagina 17

Comentarios a estos manuales

Relacionado con productos y manuales para Accesorios de comunicación Lectrosonics SMDa