Lectrosonics UH190 Manual de usuario Pagina 1

UH190 Plug-on Transmitter OPERATING INSTRUCTIONS and trouble-shooting guide LECTROSONICS, INC. Rio Rancho, NM

LIMITED ONE YEAR WARRANTYThe equipment is warranted for one year from date of purchase against defects in materials or workmanship provided it was pur

INTRODUCTION Thank you for selecting the Lectrosonics UH190 belt-pack transmitter. The UH190 combines over 80 years of engineering experience wit

Plug-on Transmitter GENERAL TECHNICAL DESCRIPTION The UH190 transmitter is comprised of a number of functional subsystems as shown in the block diagr

CONTROLS AND FUNCTIONS The UH190 may be used with a wide variety of microphones. The 3-pin XLR type connector on the UH190 allows the transmitter to

Plug-on Transmitter OPERATING INSTRUCTIONS 1) Insert the UH190 into the selected microphone. Listen for the “click” that indicates the UH190 has

BATTERY REPLACEMENT The UH190 transmitter is powered by a standard alkaline 9 Volt battery. It is important that you use ONLY an ALKA-LINE battery f

Plug-on Transmitter TROUBLESHOOTING Before going through the following chart, be sure that you have a good battery in the transmitter the red power

SPECIFICATIONS AND FEATURES Operating frequencies: 470 to 608 MHz RF Power output: 100 mW (nominal) Frequency stability: ± 0.004% Deviation: ± 15

Plug-on Transmitter SERVICE AND REPAIR If your system malfunctions, you should attempt to correct or isolate the trouble before concluding that the